Add products by adding codes
Portable pump with built-in battery
Inflating tires using this gadget is intuitive and simple. During operation, it allows you to monitor tire pressure to prevent over-inflation. You can easily control this with features such as auto-stop when a certain level is reached.
- Brand: Baseus
- Weight: 610g
- Input voltage: 5V 2.4A
- Battery capacity: 7500mAh (3 x 2500mAh)
- Rated energy: 27.85Wh
- Power: 54W
- Charging time: about 4-5 hours
- Size: 140.2x78.2x42.6mm
- Compatible with vehicle models: SUV, passenger cars, business cars, motorcycles, kayaks, bicycles, balls, air mattresses
A compact and practical gadget
The size of this pump is similar to a powerbank with a capacity of 30000mAh. The compressor has 3 batteries with a total capacity of 7500mAh, which means that you do not need to connect another cable when charging. Charging from 0 to 2.0 bar takes just 240 seconds!
The pump fits cars, other vehicles and sports accessories. Full charge applies to:
- 9 car tires in 4 minutes,
- 17 motorcycle tires in 2 minutes,
- 8 bicycle tires in 3 minutes and 40 seconds,
- 54 size 5 balls (1 minute).
The device is equipped with a tire pressure monitoring system. You can freely adjust - reduce or increase the amount of air in the tires to make everyday driving easier and more enjoyable.
The presented data concern:
- car tire pressure in the range from 2.3 bar to 2.5 bar,
- motorcycle tire pressure in the range from 1.8 bar to 3.0 bar,
- bicycle tire pressures ranging from 30 bar to 60 bar.
The smart chip stops charging when the tire pressure reaches its maximum level.
The manufacturer used metal to create a solid housing with an elegant texture. Not only does it look impressive, but it also has very good strength parameters. In addition, he has implemented solutions that allow heat dissipation - the device does not overheat. This is due to the 274 holes on each side of the housing. The cables are covered with natural rubber, which is bendable and does not break.
In addition, the design reduces noise by up to 20%!
The operation of this pump is very simple and intuitive. Buttons that are easily felt under the fingers are used here. By monitoring the tire pressure level, the risk of overloading has been reduced to a minimum. You have the following buttons at your disposal:
- M - short press turns on the device, holding for 3 seconds switches between modes,
- +/- - a short press is enough to increase or decrease the amount of pumped air,
- OK - press and hold for 3 seconds to turn off,
- Light - press to turn on the light, press again to turn on the strobe light, press again to turn on the SOS light.
The data presented on the display is for air pressure in the range of 5 to 150 psi and units (psi, bar, kpa, kg/cm2).
- Connect and install the individual parts of the pump.
- Press the M button to prepare the device for operation.
- Connect the pump to the valve and press OK to start working.
- End when charge is full.
Thanks to the LED lighting, the pump is adapted to work not only during the day, but also at night or in a dark garage. With this option, you can also send an SOS signal if necessary.
- charging cable,
- 2x nozzle,